Soap and sewing

A quantity of soap shavings came home with children after an activity.  I melted down the soap to make new bars.

How I should have started was to heat up a little water in the bottom of my laundry soap pan, and then to slowly add soap shavings and dissolve them.  Most of the time, what I had was a softened, gooey mass of soap.  Not as bad as the time I was melting old, dry, hard bits of soap, but not good.  The laundry soap pan does not have a handle, and it took some time to incorporate all of the shavings.

Near the end, I found that turning the heat up from Low to the lower side of Medium was helpful.  The soap was still not anywhere near liquid, but it was at least moldable.  

I packed it into a pan, let it cool, cut it into small bars, and have put them up to dry and harden for a few months.

I suspect they will end up a bit crumbly, but hopefully they will be usable in bar form.  If they aren't, they can go into a future batch of laundry soap.

In other projects, I have been sewing toddler pants, using fabric from old adult clothes and elastic from worn-out kids' pants.  So far I have made four pairs.  The process is a bit time-consuming when I have to pick out multiple rows of stitching to liberate the elastic, and when I have to piece fabric together to make it wide enough.

It was easier to draw up a quick pattern than to dig out an old one.  So these pants look a little goofy, too, but in a slightly different way than previous versions did.

I also worked through several items that needed mending; still have a bag full.

Yesterday I dyed some fabrics in the washer in preparation for making three skirts.  This morning I was able to sketch out a pattern and cut out two of them.  The sewing for these should be straightforward.  The third will be a circle skirt, from a circular tablecloth.

Mending and melding

I finally took a stab at my mending pile, and was able to adequately repair several items of clothing, one of which required serious darning/re-weaving where a button's stitching had ripped right out.

One of the things I did a while ago, and then forgot about, was to overdye a skirt and shirt in the washer.  The skirt had colors that were too bright, and the shirt was much too pale.  The skirt came out very nicely, and the shirt came out in a dull but tolerable shade.

I did a quick experiment with cutting a milk jug into narrow strips and then crocheting them.  Crochet uses up length very quickly, and it was difficult to cut very much of it because the scissors I was using tended to slide on the plastic.

Then I messed around with ironing the result, in between sheets of kitchen parchment paper. The plastic fused in some places and not in others.

I also tried ironing flat pieces of milk jug together to fuse them, again using parchment paper to protect the iron and working surface.  This worked, but since the plastic shrinks a bit when heated, you can't butt two edges together and expect them to stay there.  It also doesn't come out entirely flat.

At the playground, I found some stringy dead weeds that could probably be made into a rustic basket, if one reliably had their hands free for working.

I counted diapers going into the washer, and indeed as described in The Tightwad Gazette, twenty diapers equals one load of diaper laundry.  Cloth wipes are included in that, and really it is twenty diaperings rather than diapers, because I am putting a newborn-size diaper inside a larger-baby diaper at each diaper change.

And onward

I made a simple cover/sheath for a meat cleaver, from a piece of suede and some waxed thread.  The thread is extra-heavy-duty, and there was no particular need for a strong seam, so I made very large (one inch) stitches, and the sewing went very quickly:  place leather on an old phone book, poke hole with awl, make stitch, repeat.  I used my last glover's needle for the sewing, but an embroidery needle would have worked fine.

I also took up my quilt project from more than a year ago.  The quilt just needed a few more blocks made, and then to be assembled.  The last step is sewing down the edge binding by hand, and that is half done now.

My most-used quilt was waiting for a replacement back, when I looked at the cotton batting that was hanging out of it, and realized that it would need new innards as well.  The top needs more repairs besides the ones I did a few years ago, but it is worth re-using.

I read about a woman making sleeping bags for the homeless from ironed-together chip bags, and old coats, and I thought of doing something similar for making diaper covers for cloth diapers.  Then I found a laminated woven plastic rice bag that I had saved, which is much sturdier than the chip bags I ironed, and I used that instead.  I encased it in fabric in about the right shape, and added snaps. It came out looking good, but it is very much too small in the waist, so I will have to add extensions.  I hang diaper covers up to dry after washing them, so I'm not worried that the plastic might melt in the dryer.

Other things I have used the rice bags for:  wet bags for the diaper bag and for swimming stuff, and a sewing machine cover.

A child and I watched a YouTube video of a guy attempting to make bulletproof armor from milk jugs.  He had a laborious process involving cutting the plastic up with scissors, shredding it in a blender, baking it in a pan in the oven, and taking it out frequently to try to knead it smooth.  Even then, he had air pockets in his block of plastic, and it certainly wasn't bulletproof when he tested it.  From our one experiment here last year, we found that an iron generates sufficient heat to laminate flat pieces of milk jug plastic together, one layer at a time.  That was a small piece, though, and I don't know how hard it would be to keep a larger one flat as it is built up.